Kreg Accu-Cut KMA2700 Guide D'utilisation page 6

Align the Saw/Sled Assembly on the Track
4
There are three grooves in the bottom of the sled
(G). For a saw with the blade in the right-hand
sled slot, the center and left grooves ride on the track
(A) rails. For a saw with the blade in the left-hand sled
slot, the center and right grooves ride on the track rails.
Position the saw/sled assembly on the starting block,
engaging the appropriate sled grooves. Loosen the
base-plate clamp (I) set screws (H) enough to slide the
saw side to side. Align the saw so the blade will shave
" [.8mm] off the guide strip. (You'll trim the
about ⁄
1
32
guide strip later for zero-offset positioning of the track.)
Tighten the base-plate clamp set screws enough to
securely hold the saw, but do not over tighten. Make
sure the saw blade guard operates freely.
Check the Position of the Indicator Clip and Cursor
5
There are two positions on the sled for the
indicator clip (M) and cursor (N*) that correspond
to the two sled slots. Position the cursor in the holder
in front of the saw blade and the indicator clip in
the other holder. To switch indicator clip and cursor
positions, press down on the holder locks, slide
the indicator clip and cursor out of the holders and
reinstall each one in the other holder. For ease in
positioning the saw/sled assembly on the starting
block, align the notch at the front of the indicator clip
with the groove in the track rail.
ATTENTION The sled assembly is equipped with
features only functional on the Kreg Rip-Cut™. Additional steps,
found in the Rip-Cut™ manual, are required to calibrate this sled
for use on the Rip-Cut™.
Reinstall the Indexing Stop
6
The indexing stop (J) allows you to remove the
saw from the sled assembly and then re-mount it
in exactly the same position without having to re-trim
the guide strip. Place the indexing stop against the
side of the saw base and secure it to the sled with
the machine screw (K) and nut (L). For maximum
positioning flexibility, the sled is slotted and the
indexing stop can be rotated 180°.
When mounting a different saw on the sled
ATTENTION
repeat Steps 2-6. When installing a different blade in the saw,
repeat Step 4.
Assembly
G
*
N*
*The cursor is functional only on the Rip-Cut™.
A
A
Notch
K
L
G
M
Groove
J