Kreg Accu-Cut KMA2700 Guide D'utilisation page 5

Assemble the track
1
Turn the two tracks (A) upside down (black faces
of the guide strips up). Slide the connector bars
(C) halfway into the T-slots in the first track at the end
with the indicator arrows on the top face and tighten
the set screws (D). Slide the second track onto the
connector bars so the indicator arrows on the top face
align with those on the first track section. Tightly hold
the two tracks together and tighten the remaining set
screws. Slide the starting block (E) into the T-slots at
the end of one track.
The tracks can be taken apart for storage.
ATTENTION
If you disassemble the tracks, align the indicator arrows on the
top faces of the tracks when reassembling them.
Orient the Filler Strip
2
The filler strip (F) on the sled (G) is shipped with
the angled ribs facing up. These ribs support a
saw base with an angled leading edge, keeping the
saw base flat on the sled when the set screws (H) in
the base-plate clamps (I) are tightened. For a saw
base with a flat leading edge, lift the filler strip from
the sled recess with the tip of a screwdriver, turn
it over to expose the flat face, and press it into the
recess.
Mount your Circular Saw on the Sled
3
Remove the indexing stop (J) from the sled (G).
Loosen the set screws (H) in the base-plate
clamps (I) and slide your saw base plate under them.
Position the saw on the sled with the front of the saw
base plate against the step at the front of the sled. For
saws with the blade on the left-hand end of the motor,
center the blade in the left sled slot. For saws with the
blade on the right-hand end of the motor, center the
blade in the right sled slot. To accommodate different
saw base-plate configurations, there are two holes for
attaching each base-plate clamp to the sled. For the
most secure clamping, choose the holes that provide
widest spacing allowed by your saw. The clamps can
be oriented at an angle. Tighten the set screws onto the
saw base plate just enough to hold the saw in place.
Assembly
A
G
WARNING
mounting it on the sled.
D
C
C
A
H
J
Disconnect the saw from power before
E
I
G
H
K
I