Noise Level; Technical Services - Hamilton Beach Commercial HBF510 Série Manuel D'utilisation

Safety Alert Symbols
The following safety alert symbols are used throughout this manual to alert you to the safety hazards
described below.
We have provided many important safety messages in this manual and on your appliance.
Always read and obey all safety messages.
This is the safety alert symbol. It is used to alert you to potential physical injury hazards.
Obey all safety messages that follow this symbol to avoid possible injury or death.
All safety messages will be preceded by the safety alert symbol and the word "WARNING"
or "CAUTION." These words mean:
wWARNING
wCAUTION
All safety messages will identify the hazard, tell you how to reduce the chance of injury, and tell you what
can happen if the instructions are not followed.
w WARNING
w WARNING
Electrical Shock Hazard
Plug into a grounded socket.
Do not remove ground.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
w WARNING
Cut Hazard
Always place lid on jar when blending.
Do not put hands, spoons, or other utensils
in jar when blending.
Failure to follow these instructions can
result in broken bones, cuts, or other
injuries.

Noise Level

The equivalent continuous sound level when
equipment is operating at maximum speed on
no-load is less than 85 dB(A).
4
Your safety and the safety of oth ers is very important.
Electrical Shock Hazard
Disconnect power before
cleaning blender base.
Failure to follow these
instructions can result in
death or electrical shock.
WARNING indicates a hazardous situation which, if
not avoided, could result in death or serious injury.
CAUTION indicates a hazardous situation which,
if not avoided, could result in minor or moderate
injury.
Burn Hazard
Always use caution when blending
hot contents.
Failure to follow these instructions can
result in burns.
Sanitize using 1 Tablespoon (15 ml) of household
bleach per 1 gallon (3.8 liters) of clean, cool water
(60°F/16°C), mixed according to the instructions on
the bleach.
1. Fill jar to max fill line or highest graduation/
marking on jar with sanitizing solution, replace
lid and filler cap or dosing cup and run on low
speed for 2 minutes. Empty jar.
2. Wipe exterior with soft cloth dampened with
sanitizing solution.
3. Immerse lid and filler cap or dosing cup in
sanitizing solution for 2 minutes.
4. Place empty jar on base and run on high speed
for 2 seconds to remove any moisture from the
cutter assembly.
5. When ready to use, rinse with clean water.

Technical Services

For assistance or replacement parts, call or email
USA, Canada: 866-285-1087 or +1-910-693-4277,
commercial.support@hamiltonbeach.com
Mexico: 800 71 16 100,
mexico.service@hamiltonbeach.com
APAC Region: +86-400-930-2722,
hbcapac.support@hamiltonbeach.com
hamiltonbeachcommercial.com
w CAUTION
Sanitizing
Technical Services: