Publicité
Les langues disponibles
Les langues disponibles
Problem
The temperature in the
appliance is too high.
Replacing the lamp
1.
Disconnect the appliance.
2.
Push the movable part to unhook the
lamp cover (1).
3.
Remove the lamp cover (2).
4.
Replace the lamp with one of the same
power and specifically designed for do-
mestic appliances only.
5.
Install the lamp cover.
6.
Connect the appliance.
7.
Open the door. Make sure that the lamp comes on.
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to "Installation".
3.
If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension of the recess
Voltage
Frequency
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
Possible cause
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Height
Width
Depth
Technical data
Solution
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
1
2
880 mm
560 mm
550 mm
230 V
50 Hz
27
Publicité
