Installing And Threading Welding Wire - Miller R-115 Mode D'emploi

5-6. Installing And Threading Welding Wire

1 2
A
B
C
WOOD
OM-193 471 Page 18
3
Tighten
1 Retaining Ring
2 Hub Tension Adjustment Nut
If necessary, move hub on support
for use of different size wire spool.
Remove retaining ring, and install
spool so hub pin fits spool hole.
Reinstall retaining ring.
Adjust tension nut so wire is taut
when wire feed stops.
3 Pressure Assembly
Adjustment Knob
Lay gun cable out straight.
A Open pressure assemblies,
hold wire tightly, and cut off
end. Push wire through guides
into gun.
B Close and tighten pressure
assemblies. Press JOG
button until the wire comes out
of the gun.
C To adjust drive roll pressure,
press gun trigger to feed wire
against wood surface. Tighten
knob so wire does not slip.
Cut off wire. Close door.
Tools Needed:
15/16 in.
Ref. 802 308-A / S-0627-A