Philips FW-R55/25 Mode D'emploi page 19

For internal recordings you can record from the internal
CD changer or tuner.
Recording a single track
Recording a single track during playback
1
Insert a CDR(W) which is absolutely free of scratches and
dust particles in the CD recorder tray.
2
Play your desired track on the CD changer.
3
Press RECORD on the set to enter the recording menu.
REC TR and the tracknumber are displayed.
➜
4
Press either:
YES to start recording,
➜
The arrow lights,
RECORDING IN SESSION
playback and recording start from the beginning of the
selected track and the actual recording time left starts to
count down.
or
NO to continue playback.
Recording an entire CD
DISP LAY
High speed recording and automatic finalizing of
the current disc
1
Insert a CDR(W) which is absolutely free of scratches and
dust particles in the CD recorder tray.
2
Press either CD1, CD2 or CD3 to select the disc you wish
to copy.
3
Press COPY CD on the set to enter the recording menu.
➜ The arrow starts blinking.The remaining recording time
of the CDR(W), the total playing time of the source CD
and RECORD CD1 (or 2, 3)? are displayed.
All manuals and user guides at all-guides.com
is shown,
ON•OFF
LEVEL
AUX
MIC /
LEV EL
MIC
Internal recording
4
Press YES to start recording and finalizing.
➜
The arrow lights,
RECORDING IN SESSION
speed recording at a low volume and finalizing start and
the actual recording time left starts to count down.
Note: If a program was already available before pressing
COPY CD, this will be ignored.
disc will be recorded. After finishing the recording,
shown and the program is available again.
Recording a program
High speed recording and automatic finalizing
(optional) of the current program
1
Insert a CDR(W) which is absolutely free of scratches and
dust particles in the CD recorder tray.
2
Press COMPILE CD on the set to enter the recording menu.
➜
The arrow starts blinking.The remaining recording time
of the CDR(W), the total playing time of the source CD
and RECORD PROG? are displayed.
Note: If no program is available and you press COMPILE CD,
you will enter immediately the program menu. Start your
programming and return to the recording menu by pressing
PROG or COMPILE CD.
3
Press either:
YES to confirm,
or
NO to change the program.
➜
starts blinking. Now you can change the program
PROG
(see "Program") and return to the recording menu by
pressing COMPILE CD.
AUTO FINAL? is displayed.
4
Press either:
YES, if the CDR(W) is to be finalized after recording,
or
NO, if the CDR(W) is not to be finalized after recording.
➜
The arrow lights,
RECORDING IN SESSION
speed recording and finalizing (if selected) start and the
actual recording time left starts to count down.
is shown, high
goes off and the current
PROG
is
PROG
is shown, high
19