Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE LED ASSEMBLY AND GLASS SHADE
WARNING: Before starting installation, disconnect the power by turning off
the circuit breaker or removing the fuse at fuse box. Turning power off
using the fan switch is not sufficient to prevent electric shock.
Remove the 1 of 3 screws from the posts of the light kit decora
tive housing and keep it for future use. Loosen the other 2
screws. (Do not remove)
While holding the LED light kit under your fan, make the polarize
2
plug connections: (Fig. 2)
- Red to white
- Black to black
3
Place the key holes on the LED assembly over the 2 screws
previously loosened, turn the light plate until it locks in place at the
narrow section of the key holes. Secure by tightening the 2 screws
previously loosened and the one previously removed. (Fig. 1)
Raise glass shade up against adapter plate and secure it to the
4
fan by turning the glass shade clockwise until snug. DO NOT
OVERTIGHTEN.
5
Restore power and your light kit is ready for operation.
10
| hinkley.com
Wire Connectors
Adapter Plate
LED
Assembly
Fig. 1
Adapter Plate
Glass
Shade
Fig. 2
Screws
Publicité
