Publicité
1. Engine oil filler cap
1. Bouchon de remplissage d'huile de moteur
1. Tapa del orificio de llenado de aceite de motor
1. Dipstick
3. Minimum level mark
1. Jauge
3. Repère de niveau minimum
1. Varilla
3. Marca de nivel minimo
2. Maximum level mark
2. Repère de niveau maximum
2. Marca de nivel máximo
Engine oil and oil filter element
The engine oil level should be checked before
each ride. In addition, the oil must be changed and
the oil filter element cleaned at the intervals speci-
fied in the periodic maintenance and lubrication
chart.
To check the engine oil level
1. Place the ATV on a level surface.
2. Warm up the engine for several minutes, and
then turn it off.
3. Wait a few minutes until the oil level settles
before checking.
4. Remove the engine oil filler cap, and then
wipe the dipstick off with a clean rag. Insert
the dipstick in the filler hole (without screwing
it in), and then remove it again to check the oil
level.
NOTE:
_
The oil level should be between the minimum and
maximum level marks.
_
8-17
EBU12334
Publicité
