Machine Set Up Guide - Numatic CRO 8055 Notice Originale

Machine Set-up Guide
!
PLEASE READ BEFORE COMMENCING ANY OPERATION AFTER THE REMOVAL OF ALL
CONTENTS
1 x Owner Manual
2 x Battery Charging Lead
2 x Keys
1 x 40 Amp Fuse (1 spare)
1 x Maxi Fuse-puller
Lift top tank assembly to reveal
battery compartment.
Always lift using handle grips as shown.
Remove transit block from pallet.
"
Ensure that no metal objects
come into contact with
battery terminals while the
batteries are exposed.
ALWAYS WEAR GLOVES.
When inserting the first
fuse you may notice
a spark, this is normal.
NOTE: DO NOT depress accelerator pedal while software initialises.
The seat is fitted with a pressure sensor that disables the machine until an operator is seated.
Set lever to forward.
8
www.numatic.co.uk
THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS.
"
Fit the battery fuse.
Set to slowest speed, depress accelerator and
drive off the palette using ramp provided.
Use handle grip when
raising or lowering the
top waste-tank.
Switch on the machine.
Once in a safe location switch off machine.
!