Quick Set-Up Guide - Numatic ETB 1120 Mode D'emploi

!
After the removal of all the packaging, carefully open and check the contents.
1
2
3
4
Fig 7
5
Fig 8
PLEASE READ BEFORE COMMENCING ANY OPERATION.
Ensure the Batteries are charged before use.
Using the handle position lever
(Fig 1), move the handle into the
upright position. (Fig 2).
Fig 1
Connect 24V power supply to
the machine
Fig 3
Place the top tank (waste water) into the machine (Fig 5) and connect the
vacuum
Fig 5
Fit the isolator key and switch the machine on (Fig 7).
Fill the bottom tank (Clean Water) from a tap or hose pipe using the Flexi-Fill pipe fitted to
the filler cap (Fig 8). Add Non foaming cleaning fluid as required (See page 11).
The ETB 1120 has a water capacity of 11 gal
Fig 4
and floor tool hose to the separator (Fig 6).
Note:
Great care must be taken to ensure that contaminants
(leaves, hair, dirt, etc.) are not allowed to enter the
clean-water tank during the filling process.
If using a bucket or similar, ensure it is always clean
and free from debris.
8

Quick Set-Up Guide

!
Fig 2
Fig 6