Publicité
Les langues disponibles
Les langues disponibles
SAFETY INFORMATION
Please read and understand the entire manual before attempting to assemble, operate or install
the product.
If you feel you do not have sufficient electrical experience, have the fixture installed by
a qualified
licensed electrician.
the circuit breaker or by
is not sufficient to prevent electrical shock.
This unit is suitable for indoor use only. To avoid risk of electrical shock or fire, do not modify this
lamp; if any modification is made, it may render the product unsafe.
CAUTION
Before assembling and installing your lighting fixture, refer to the section titled ELECTRICAL
CONNECTIONS. To ensure the success of the installation, be sure to read these instructions
and review the diagrams thoroughly before beginning.
All electrical connections must be in accordanc e with local codes, ordinances, or the National
Electrical Code.
Dimmable to 10% with select dimmers : : Lutron 603PGH, Lutron CTCL-153PDH, Lutron
DVWCL-153-PDH, Lutron S-603P.
ELECTRICAL CONNECTIONS
Required Supply Circuit: 120 V, 60 Hz.
Connect the white wire from the fixture to the white wire of the supply circuit.
Connect the black wire from the fixture to the black wire of the supply circuit.
Connect the green (or bare copper) wire to the grounding conductor of the supply circuit.
U
s
e
. U
. L
C /
S
A
s i l
e t
d
i w
No loose strands or connections should be present.
Secure wire connectors with U.L./CSA listed electrical tape.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment on
and off, the user is encouraged to try to correct the interference by one or more of the following:
Reorient or relocate the receiving antenna.
Increase the separation between the lighting unit and receiver.
Connect the lighting unit into an outlet on a circuit other than the outlet which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for assistance.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not attempt
to assemble the product.
Estimated Assembly and Installation Time: 20 - 30 minutes
Tools Required for Assembly (not included): Phillips screwdriver, Flathead screwdriver, Wire
cutters, Pliers, Safety goggles, Electrical tape, Stepladder
Helpful Tools (not included): Wire stripper
Before starting the installation, disconnect the power by turning off
e r
m
o
v
n i
g
h t
e
u f
s
e
t a
e r
connectors suitable for the size, type and number of conductors.
h t
e
u f
s
e
b
o
x. Turning the power off to the light switch
3
Lowes.com
Publicité
