Télécharger Imprimer la page

EFBE-SCHOTT TO 400 Mode D'emploi page 7

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Fax +32 2 359 95 50
OPERATION
Before using your appliance for the first time, check if it is clean (see "Maintenance and
cleaning") as it comes into direct contact with bread. Check if any object has fallen into
the slot.
In the first time, connect the appliance only to a mains earthed wall socket. A grommet
on the bottom of the appliance enables to maintain the cord by positioning it to the
backside of the appliance.
Place the bread slices in the slot (for the French bread, cut a loaf shorter than the slot,
then cut it in two pieces along its length). Your appliance is provided to receive French
bread, but also pieces of toast or other bread slices if their thickness and their length are
shorter than the one of the slot.
Press down the bread carriage handle until it stops. Then release the pressure and the
handle will stay in the lower position, which means that the heating process has begun. If
the handle comes up immediately, check if the appliance is plugged in as the handle
blocks only when the unit is plugged in.
You can adjust the browning intensity to obtain a more or less toasted bread by
positioning the browning control selector to one of the degrees marked from 1 to 6.
Therefore you only have to turn clockwise to increase the intensity, and anticlockwise to
decrease it. The higher the number is, the more toasted the bread will be.
During the functioning, if you think that the bread is toasted enough or for another reason,
you can break the heating process, simply by pressing the cancel button.
Always unplug the appliance after use and let it cool down before handling or storing it.
When storing your appliance, wind the cord around the cord storage facility underneath
the appliance and attach the end of the cord in the notch.
RACK FOR BUN WARMING
Your appliance is provided with a bun warmer. To warm the buns, just place the support on the
top of the toaster.
MAINTENANCE AND CLEANING
Before attempting any cleaning operation, make sure the toaster is unplugged from the
supply socket and fully cooled down.
To remove breadcrumbs, slide the crumb tray situated on the side of the appliance. To
open it, slide it horizontally. To close it, proceed inversely.
Never use sharp objects to clean. Doing so could damage the appliance.
To clean the exterior surfaces, simply wipe over with a soft damp cloth. On no account
must the toaster be immersed in water.
All other maintenance and repair should be performed by a qualified technician. No
guarantee claims will be accepted if the appliance has been opened inappropriately.
PROTECTION OF THE ENVIRONMENT– DIRECTIVE 2002/96/EC
In order to preserve our environment and protect human health, the waste electrical and
electronic equipment should be disposed of in accordance with specific rules with the
implication of both suppliers and users. For this reason, as indicated by the symbol
rating label or on the packaging, your appliance should not be disposed of as unsorted
municipal waste. The user has the right to bring it free of charge to a municipal collection point
performing waste recovery by means of reuse, recycling or use for other applications in
accordance with the directive.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
7
Assembly page 7/7
on the
SC TO 400 - 090204

Publicité

loading