Ricatech RR3000 Retro Classic Mode D'emploi page 13

From Phono to SD / USB
The system is capable to convert audio signal from PHONO input to MP3 format and store in USB mass storage device or SD
card (default USB if both devices are detected)
1. Press the FUNCTION /
2. Press REC / to start ripping, the system will scan the contents of USB/SD card and create folder to store MP3
tracks.
3. Icon ― REC ‖ and message ― RIPP TO‖ are displayed, icon ― PHONO ― start flashing.
4. The target device icon ― USB ‖ or ― CARD ‖ start flashing as ripping begins.
5. Press STOP / to exit PHONO ripping
From AUX to SD/USB
The system is capable to convert audio signal from AUX input to MP3 format and store in USB mass storage device or SD card
(default USB if both devices are detected).
1. Press FUNCTION /
2. Press REC / to start ripping, the system will scan the contents of USB / SD card and create folder to store
MP3 track.
3. Icon ―REC‖ and message ― RIPP TO ― are displayed, icon ― AUX ― start flashing.
4. The target device icon ― USB ― or ― CARD ― start flashing as ripping begins.
5. Press STOP / to exit AUX ripping
Note: The message ― NO FUNCT ― will be displayed if any key pressed during AUX ripping process. The message ―
NO DEV ― will be shown if neither USB or SD card not detected. The message ― FULL ― will be displayed if not enough
memory in target device.
Delete MP3 tracks
The system support deleting previous recorded MP3 or existing files.
1. In USB or SD card playback mode, press and hold REC/ERASE /
and will be deleted.
2. Message ― delete ― is displayed
to set the unit to PHONO mode.
once or more to select AUX
for 2 seconds, current playback track is stopped