AXXAIR 121FS29 Mode D'emploi page 18

12. Penetration adjustments:
- Put the blade in its working position. The index plunger of the penetration lever in the screw
head on the steel plate (Fig.01).
- Move the tube forward to the edge of the clamping jaws so that it is slightly back in relation to
the tool. Clamp the tube to ensure a good geometry of the adjustments (Fig.02).
Loosen the knurled screw of the penetration lever (Fig.03) and swivel the tool support plate
-
(Fig.04) so that the top teeth of the cutting tool protrude from 1 to 2 mm into the interior of the
tube (Fig.05).
- Retighten the knurled screw of the penetration lever (Fig.03) when the adjustments are done.
Lift back up the penetration lever to disengage the cutting tool (Fig.06).
-
This adjustment is necessary each time you change tube diameter and/or thickness.
-
Fig.01
Fig.04
13. Cutting step by step:
Warning: Always check that the tube does
not bump up against the saw blade when it is
put into the cutting machine and that it is
correctly aligned with the cutting machine.
Before starting the cutting motor, make sure
that there are no foreign bodies left in the
cutting area.
- Tightening the hold on the tube (1).
Starting the cutting motor (2).
-
Penetration into the tube (3).
-
Rotating around the tube (4).
-
Disengaging from the tool after the cut is
-
made (3).
Stopping the cutting motor (2)
-
Loosening the hold on the tube.
-
The cut is finished.
ENGLISH
- 18 -
F-26800 ETOILE-SUR-RHONE
Fig.02
Fig.05
Direction of advancement of
the cutting tool
2
3
Z.I. Les Bosses
www.axxair.com
Fig.03
Fig.06
4
1