AXXAIR 121FS29 Mode D'emploi page 15

5. Mounting on a workbench:
The cutting machine can be installed and
bolted on a workbench. Attention should be
paid to the stability of the assembly (cutting
machine + workbench + the tube to be cut),
and also to the load that can be supported by
the workbench.
Weight of the tubes
Material Ext Ø
Steel/Stainless 114.3
mm
Steel/Stainless 168.3
mm
Steel/Stainless 219.1
mm
Steel/Stainless 323.9
mm
For some models, foot supports can be
supplied as an option.
6. Cutting tools:
When the machine is delivered, a blade is
installed on the cutting motor. You should
check that it corresponds to the tube you wish
to cut.
WARNING: It is imperative that the cutting
motor be disconnected from the power supply
before any handling of the motor or the cutting
tool.
AXXAIR saw blades are designed specially for
your orbital cutting operations. They are made
from high quality steels for optimal longevity.
They adapt to all types of materials currently
used.
The thickness of the tube being cut determines
the choice of blade to be used.
Reference: Thickness to be cut:
LS63128
LS63100
LS6364
LS6872
LS6844
LS8080
LS8054
LS8034
LS9038
Blades with large teeth are always preferable
when the thickness to be cut is at the limit of
the capacity shown above.
ENGLISH
Thickness Weight /
m
15 mm 37 kg
15 mm 57 kg
15 mm 76 kg
15 mm 115 kg
0.5 to 0.7 mm
0.7 to 1.5 mm
1.0 to 3.0 mm
1.0 to 3.0 mm
2.0 to 7.0 mm
1.0 to 3.0 mm
2.0 to 7.0 mm
5.0 to 12.0 mm
5.0 to 15 mm
F-26800 ETOILE-SUR-RHONE
The arrow indicates the tool's direction of
rotation.
The hole positions the cutter and avoids all
excessive clamping during usage.
7. Installing the tool on the motor:
WARNING: The motor should always be
disconnected from the power supply.
These tools are sharp; appropriate gloves
should therefore be used when installing and
uninstalling the cutting tools.
Note: All support surfaces should always be
cleaned.
Place the blade in such a way that the
-
direction of rotation shown on the tool
corresponds to the direction of rotation
of the cutter's motor. With this type of
tool we always counterwork, i.e. the
direction of rotation of the tool is the
opposite to the direction of rotation of the
forward motion.
- Place the disc over the blade, ensuring
that the pin is correctly positioned.
Note: The pin is not a driving bolt; it's used
to prevent the blade from over-tightening
during usage and to allow easy uninstalling
and changing of the blade.
If the cutting tool used does not have a
-
hole, mount the support disc with the pin
toward the exterior.
Put the nut in place and tighten with the
-
key provided for that purpose. It needs to
be tightened hard (by tapping the key) to
keep the tool from loosening.
Note: The brass nut (yellow) tightens
counter clockwise,
tightening and loosening is therefore
reversed in comparison to a normal thread.
- 15 -
Z.I. Les Bosses
www.axxair.com
the direction of