Ryobi P795 Manuel D'utilisation page 6

INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 8.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, refer to the Operator's
Manuals for your battery pack and charger models.
WARNING:
Always remove battery pack or disconnect power cord
from the product when you are assembling parts, making
adjustments, cleaning, or when not in use. Removing
battery pack or disconnecting power cord will prevent
accidental starting that could cause serious personal
injury.
INSTALLING/REMOVING POWER CORD
See Figure 2, page 8.
WARNING:
Do not route cord under carpets, rugs, runners, furniture,
or appliances and always route cord away from traffic
areas to prevent a tripping hazard.
 Remove the battery pack.
 Insert the female end of the power cord into the product
as shown.
 Connect the male end of the power cord to the power
source.
 Make sure the power cord is secured before beginning
operation.
WARNING:
Keep light away from combustible materials. If wrapped
or in contact with fabrics, the work light lens can produce
sufficient heat to melt some fabrics. To avoid serious
personal injury, never allow the work light lens to come
in contact with anything.
OPERATION
ADJUSTABLE HEAD
See Figure 3, page 8.
CAUTION:
Do not place hands or fingers between adjustable head
and frame when positioning work light to avoid pinching
your fingers or hands.
To adjust the direction of the light, twist the adjustment
knob counterclockwise. Rotate the light head to the desired
position and turn the adjustment knob clockwise to tighten.
POWER BUTTON
See Figure 4, page 9.
The light will be in the OFF position until the power button
is pressed.
 Connect the product to an AC or DC power supply.
 Press and release the power button three times to turn
the light on and cycle through high, medium, and low
brightness levels.
 Pressing and releasing the power button a fourth time
turns the light OFF.
NOTE: This light is equipped with a low voltage indicator. If
the light flashes 3 times while a battery pack is installed, this
indicates a low charge condition. Three additional flashes
indicate that shutdown will follow quickly. Install a charged
battery pack and resume operation.
CORRELATED COLOR TEMPERATURE (CCT)
See Figure 5, page 9.
Correlated color temperature (CCT) defines the color
appearance of a white LED. This light allows you to select
the color appearance by rotating the power button.
 Turn the power button all the way counterclockwise to
select the coolest lighting temperature.
 Turn the power button gradually clockwise to select light-
ing in the neutral temperature range.
 Continue to turn the power button clockwise and the color
temperature will become warmer.
 At any point in color temperature selection, you can select
a high, medium, or low light intensity.
6 – English