HomeMatic HmIP-WTH-1 Notice D'installation Et Mode D'emploi page 36

Operation
The wall thermostat is designed to fit into frames supplied by the follow-
ing manufacturers:
Manufacturer
Berker
ELSO
GIRA
merten
JUNG
6 Operation
After configuration, simple operations are available directly on the device.
If the wall thermostat is in standby mode, please press the control
wheel (E) once before operation to activate the device.
• Temperature: Turn the control wheel (E) to the right or to the
left to manually change the temperature. In automatic mode,
the manually set temperature will remain the same until the next
point at which the schedule changes. Afterwards, the defined
heating schedule will be activated again. During manual oper-
ation, the temperature remains activated until the next manual
change.
• Boost function for Homematic IP Radiator Thermostats: Press
the control wheel (E) of the wall thermostat briefly to activate
the boost function for heating up the radiator quickly and briefly
by opening the valve. There will be a pleasant room temperature
right away because of the radiated heat.
36
Frame
S.1, B.1, B.3, B.7 glass
Joy
System 55, Standard 55, E2, E22, Event, Esprit
1-M, Atelier-M, M-Smart, M-Arc, M-Star, M-Plan
A 500, AS 500, A plus, A creation