Publicité
Les langues disponibles
Les langues disponibles
5.2.1
Adhesive strip mounting
For mounting the assembled wall thermostat with the adhesive strips,
please proceed as follows:
•
Choose a site for installation.
Make sure that the mounting surface is smooth, solid, non-dis-
turbed, free of dust, grease and solvents and not too cold to ensure
long-time adherence.
Fix the adhesive strips (G) on the back side of the mounting plate
•
(F) in the provided area. Make sure that you can read the letters on
the back side (H) (see figure 3) and that the clips on the mounting
plate latch into the openings on the wall thermostat.
•
Remove the protective film from the adhesive strips.
•
Press the assembled wall thermostat with the back side to the wall
in the position where it should subsequently be attached.
5.2.2
Screw mounting
For mounting the wall thermostat by screws, please proceed as follows:
•
Choose a site for installation.
Make sure that no electricity or similar lines run in the wall at this
location!
Position the mounting plate (F) on the desired site on the wall.
•
Make sure that the arrow on the mounting plate is pointing up-
wards.
•
Use a pen to mark the positions of bore holes (J) (diagonally op-
posite) in the mounting plate on the wall (see figure 4).
•
Now drill the bore holes.
If you are working with a stone wall, use a 5 mm drill bit for the wall
plugs supplied. If you are working with wooden walls, you can use a
1.5 mm drill bit to make it easier to screw in the screws.
Start-up
33
Publicité
