VelLight LEDA211NW Mode D'emploi page 6

6. Connection
Refer to the illustrations on page 2 and 3 of this manual.
1. Open the base at the back of the lamp.
2. Loosen the 4 screws of the connection compartment using an
appropriate screwdriver.
3. Slide the power cable through the rubber seal and connect to the
screw terminal.
4. Close the connection compartment and secure with the screws.
5. Close the base of the lamp.
6. Install the bulkhead lamp.
7. Cleaning and Maintenance
 This luminaire does not have a built-in device to disconnect it from the
electric mains. Make sure to electrically isolate the luminaire before
installation or maintenance activities are performed.
 All screws should be tight and free of corrosion.
 The housing, the visible parts, the mounting supports and the
installation location (e.g. ceiling, suspension, trussing) should not be
deformed, modified or tampered with; e.g. do not drill extra holes in
mounting supports, do not change the location of the connections...
 The electric power supply cables must not show any damage. Have a
qualified technician maintain the device.
 If the protective glass is damaged, disconnect the lamp immediately
from the mains. Have it repaired immediately by a qualified technician.
Do not use the lamp with a cracked or broken protective glass.
 Wipe the device regularly with a moist, lint-free cloth. Do not use
alcohol or solvents.
 There are no user-serviceable parts.
 Contact your dealer for spare parts if necessary.
8. Technical Specifications
electrical data
power LED module
total nominal power
nominal voltage driver
power factor
energy consumption (kWh/1000 h)
V. 02 – 15/02/2016
LEDA211NW/LEDA212NW
6
25 x 5730 LEDs
10 W
230 V~
>0.9
10
©Velleman nv