Publicité
Les langues disponibles
Les langues disponibles
Water
Line
Use adjustable
wrench here.
Setscrews
Clean or Replace the Cartridge
Remove the Cartridge
If the faucet is installed to wall storage: Lift up on the lower
edge to open the wall storage.
If the faucet is installed to a shelf: Remove and retain the four
screws from the underside of the shelf. The lower portion of the
shelf will drop down.
Loosen the setscrews from the mounting sleeve to allow the spout
assembly to move freely.
IMPORTANT! Do not disconnect the water line from the rear
housing.
Hold the rear housing in place with an adjustable wrench while
turning the front housing counterclockwise with your thumb and
forefinger. This will loosen the front housing from the rear
housing.
Slide the front housing off of the rear housing.
NOTE: When removing the front housing from the rear housing,
residual water will be present.
1070285-5-A
Rear
Mounting
Housing
Sleeve
Cartridge
Front
Housing
4
Spout
Assembly
Knurl
Kohler Co.
Publicité
