Refreshing Carpets - Reliable STEAMBOY 200CU Guide D'utilisation

2. After a few seconds the green Steam Ready light will illuminate indicating the
cleaner is ready for use.
3. Recline the cleaner by placing a foot on the floor head and lowering the main
body towards the floor. [8]
4. To produce steam press the Steam Trigger Button. [9] - It's best to use the
steam intermittently so that the pad does not become over-saturated with
water.
5. Move the cleaner slowly backwards and forwards paying particular attention to
high traffic areas. [11]

REFRESHING CARPETS

NOTE: Always sweep or vacuum the floor prior to use to remove any loose dirt
or debris.
IMPORTANT: Do not use the cleaner without a microfiber pad attached to the
floor head.
1. Attach the carpet glide to the floor head. [10]
2. Plug the steam cleaner into the main power. The blue ON light will illuminate
3. After a few seconds the green Steam Ready light will illuminate indicating the
cleaner is ready for use.
4. Recline the cleaner by placing a foot on the floor head and lowering the main
body towards the floor. [8]
5. To produce steam press the steam release button. [9] - It's best to use the
steam intermittently so that the pad does not become over-saturated with
water.
6. Move the cleaner slowly backwards and forwards paying particular attention to
high traffic areas. [11]
MAINTENANCE
IMPORTANT: always ensure the cleaner has fully cooled down before performing
any maintenance tasks.
EMPTY THE WATER TANK
1. Unplug the cleaner from the main power and ensure the unit has cooled.
2. Remove the clean water tank for the main body of the cleaner. [4]
3. Twist the cap anti-clockwise and remove. [5]
4. Empty any excess water from the tank. [12] Replace the cap and return to
the cleaner.
9