Publicité
Les langues disponibles
Les langues disponibles
Menu 12, Last Card (ATS1115/1116 only)
This option displays the number of the last card badged on an
ATS1115 or ATS1116 reader, in the format: Facility Code /
System Code, ID Number or as raw card data (depends on
setting of security mode).
Technical data
Supply voltage
Maximum operating current
Normal operating current (all areas
armed)
Open collector output ("OUT"
terminal)
Wireless operating frequency
Maximum power output
Dimensions with cover (W x H x D)
Weight
Operating temperature
Humidity
Code combinations:
5 digits
9 digits
IP rating
ACE type (tamper protection)
Regulatory information
Manufacturer
Carrier Fire & Security Americas Corporation Inc.
13995 Pasteur Blvd
Palm Beach Gardens, FL 33418, USA
Authorized EU manufacturing representative:
Carrier Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, Netherlands
Product warnings
THESE PRODUCTS ARE INTENDED FOR
and disclaimers
SALE TO AND INSTALLATION BY QUALIFIED
PROFESSIONALS. CARRIER FIRE &
SECURITY CANNOT PROVIDE ANY
ASSURANCE THAT ANY PERSON OR ENTITY
BUYING ITS PRODUCTS, INCLUDING ANY
"AUTHORIZED DEALER" OR "AUTHORIZED
RESELLER", IS PROPERLY TRAINED OR
EXPERIENCED TO CORRECTLY INSTALL
FIRE AND SECURITY RELATED PRODUCTS.
For more information on warranty disclaimers and
product safety information, please check
https://firesecurityproducts.com/policy/product-
warning/
Certification
EN 50131-1 System requirements
EN 50131-3 Control and indicating equipment
Security Grade 3, Environmental class II
Tested and certified by Telefication B.V.
P/N MAINST-ATS111x (ML) • REV F • ISS 14DEC20
ATS1110/1111
ATS1115/1116
with smart
card reader
8.5 to 14.0 V
95 mA at
165 mA at
13.8 V
13.8 V
26 mA at
35 mA at
13.8 V
13.8 V
15 V max. at 50 mA max.
—
125 kHz
—
65.7 dBµA/m
at 10 m
92 x 165 x 25.4 mm
(3.6 x 6.5 x 1 in.)
300 g
−10 to +50°C (+22 to 122°F)
< 95% non condensing
100 000
1 000 000 000
IP30
B
or scan the QR code.
REACH
305 g
Contact information
www.firesecurityproducts.com or www.aritech.com
For customer support, see www.firesecurityproducts.com
DA: Installations vejledning
Montering af enheden
Lågen på RAS-enheden er hængslet i bunden. Åbnes ved at
tage fat i siderne eller toppen af lågen og trække forsigtigt —
hvorefter lågen svinger ned på hængslerne. Lågen kan fjernes
helt ved forsigtigt at vride et af hængslerne væk fra RAS-
enhedens kabinet og trække. Metalmonteringspladen på
bagsiden holdes fast af en låseskrue. Monteringspladen
fjernes ved at løsne skruen mindst 8 mm, skubbe
monteringspladen ned og derefter trække bunden af
monteringspladen væk fra RAS-enhedens kabinet.
Fastgør metalmonteringspladen på monteringsstedet vha. de
tre medfølgende skruer. Hvis kabelt er ført gennem væggen
hvor RAS-enheden skal placeres skal monteringspladen
fastgøres over kablet. Indstil RAS-adressen vha. DIP-
switchene 1 til 4 (se "Indstillinger for RAS DIP-switches" på
side 6). Indstil BUS-termineringsswitchen (DIP-switch 5), hvis
det er relevant. Terminer bus-kablet.
ADVARSEL:
afbrudt, inden RAS-enheden forbindes.
Indsæt plastikblændpropper (medfølger) i alle ubrugte
kabelindgange på siderne af RAS-enheden for at spærre
indgangene. Placer RAS-enheden på monteringspladen, og
lås den fast ved at rykke enheden omkring 8 mm ned. Stram
låseskruen i bunden af RAS-enheden. Pas på ikke at stramme
for meget.
ATS1110, ATS1111: Carrier Fire & Security
hereby declares that this device is in compliance
with the applicable requirements and provisions of
the Directive 2014/30/EU and/or 2014/35/EU. For
more information see
www.firesecurityproducts.com
ATS1115, ATS1116: Carrier Fire & Security
hereby declares that this device is in compliance
with the applicable requirements and provisions of
all applicable rules and regulations, including but
not limited to the Directive 2014/53/EU. For more
information see www.firesecurityproducts.com
Product may contain substances that are also
Candidate List substances in a concentration
above 0.1% w/w, per the most recently published
Candidate List found at ECHA Web site.
Safe use information can be found at
https://firesecurityproducts.com/en/content/intrusi
on-intro
2012/19/EU (WEEE directive): Products marked
with this symbol cannot be disposed of as
unsorted municipal waste in the European Union.
For proper recycling, return this product to your
local supplier upon the purchase of equivalent
new equipment, or dispose of it at designated
collection points. For more information see:
recyclethis.info
Al spænding til centralenheden skal være
5 / 52
Publicité
