ABUS Security-Center Eyseo TV7600 Instructions D'installation page 51

B. Ceiling mount type
The Ceiling mount type is for suspended ceilings with at least 4 cm distance between structural
slab and ceiling. The complete camera body will be visible.
1. Select a ceiling board which is strong enough to hold a weight of approximately 2kg.
2. Prepare a Ø145mm hole in the ceiling board. (FIG.9)
Fix the safety wire to a suspension to prevent camera from falling.
Fix the other side of safety wire to the safety wire hole. (FIG.10)
3. Fix the Ceiling Mount to the Ceiling with 4 screws (Ø4.0mm tapping screw). (FIG.11)
4. Tie the wire using the cable ties. (FIG.12)
5. Mount the wires through the square hole.
Place the Camera Mount Holder in the Bracket Mount Hole. (FIG.12)
To insert them easily, keep 10° interval of Lock Holder1 and Lock Holder2. (FIG.13)
51