Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
If you experience a problem with your appliance or are concerned that the appliance is not functioning
correctly, you can carry out some easy checks according to below table before calling for service.
Warning !
Do not try to repair the appliance yourself. If the problem persists after you have made the checks
mentioned below, contact a qualified electrician, authorized service engineer or the store where you
purchased the product.
Problem
Appliance does not operate.
Unusual noises
Inadequate refrigeration
Door seal fails to be tight.
Possible Causes & Solution
x
Check that the appliance is plugged into the mains socket
properly and that the outlet is switched on.
x
Check the fuse is not blown.
x
Check the circuit breaker is not tripped.
x
Re-adjust the feet to ensure the appliance is level.
x
Check that the appliance is not touching the wall or other
objects. Move the appliance slightly.
x
Check that a component, e.g. a pipe, on the rear of the
appliance is not touching another part of the appliance or
the wall. If necessary, carefully bend the component out of
the way.
x
Set the temperature control to a lower temperature and
allow several hours for the temperature to stabilize.
x
Door is kept open too long or is opened too frequently.
Warm air enters the refrigerator every time the door is
opened. Open the door less often.
x
Check that the door is closed completely.
x
Ensure that the door gasket does not seal properly.
x
A large amount of warm or hot food might have been
stored recently. Wait until the refrigerator has reached its set
temperature.
Remove foreign matters on the door seal.
Heat the door seal and then cool it for restoration.
(or blow it with an electrical drier or use a hot towel for heating)
EN-19
Publicité
