Connection; Connecting The Chinch Inputs - Renkforce E-SA9M Notice D'emploi

Connection

Make sure that the mains plug is unplugged before connecting the device and that the volume
control VOLUME (16) is set to minimum (left stop). Before connecting the device, turn off all
other equipment to be connected to the mixing desk.

Connecting the chinch inputs

For the connection of the cinch inputs only use the shielded cinch wires. The use of other
cables might cause interferences. To avoid distortion or mismatching that may damage the
device, only sources with a cinch output may be connected to the cinch inputs of the device.
You may connect devices with a LINE output level, a CD player or cassette deck, to the stereo
cinch inputs of the amplifier.
These inputs are not suitable for the direct connection of a record player. In this case, you have
to switch an equalizer pre-amplifier upstream.
The white cinch socket of the amplifier is connected with the left cinch output of the respective control source (e.g.
CD player).
The red cinch socket of the amplifier is connected with the right cinch output of the respective control source (e.g.
CD player).
(17) Cinch input AUX
This is where you connect the audio cinch output sockets of a cassette recorder, video recorder, satellite receiver,
etc.
(18) Cinch input TUNER
Connect the audio cinch outputs of the radio to these connections.
(19) Cinch input CD
Connect the audio cinch outputs of the CD player to these connections.
30
Operating Instructions

English