Publicité
Les langues disponibles
Les langues disponibles
Descaling
6
8
NOTE
• Run decalcification every 3 months or after 300 cycles.
• Total run time is 5 mins at a watertemperature of 65 °C
• Start the decalcification program only when the appliance is COLD (CLEAn button lights up). Decalcification
program will not start if appliance is HOT (All buttons light up)
7
Preparation
Switch off the appliance
Fill water tank and add
and remove all accesoiries
descaler to recommended
ratio on box
Decalcification
Hold down the clean but-
When CLEAn button
ton and switch on power
lights up the appliance
untill all buttons light up
is ready for decal cycle.
Press CLEAn button
NOTE
• * Make sure there is no descaler left in water tank.
• After decalcification & rinse process, switch off the appliance to exit the decalcification mode.
Switch appliance off,
Clean the water tank
GB
remove water tank and
and froth head under
froth head
12
Place large glass or
container underneath
the milkoutlet
After decalcycle clean
and refill water tank*
(keep appliance
switched on)
Attach froth head
and cleaning cup and
tap water
switch appliance on
Troubleshooting
Faults
Indicator lights do not flash after
switching on the appliance
no milk flow
Button B flash fast
Button A flash fast
NOTE
• If you cannot solve the problem following the steps outlined above, please contact the customer service.
2x 5 min.
Storage / Disposal
If you do not need the appliance for an extended period of time, allow it to cool down and clean the appliance
as described in the chapter Cleaning and Care to prevent mould formation. Mould fungus represents a health
risk and stains may develop on the unit which can no longer be removed. Electric and electronic end-of-life
appliances often still contain valuable materials. However, they also contain hazardous substances which
were required for their proper function and safety. If disposed of with regular household waste or treated
incorrectly they can pose a risk to human health and the environment.
Press CLEAn button
NOTE
once for 5 min. run with
tap water. Run 2 times
• Use the collecting station in your municipality to return electrical and electronic end-of-life appliance for
recycling. Obtain the information required, if necessary, from your city hall, your waste disposal company
or your dealer.
• Render the appliance unusable before disposal. Make sure your end of life appliance is stored safely away
from children until hauled away.
Technical data
2x 60 sec.
Dimensions (W x H)
Approx. weight
Operating voltage
Frequency
Power consumption
Length of cable
Run the 'Long clean'
program at least 2
Watertank
times. After this the ap-
Milktank
pliance is ready for use
Possible cause
Repairs
Plug not in socket or power cord
Connect plug
connector
• Water tank empty
• fill water tank
• front cover not attached properly
• Attach front cover
• Suction pipe from milk tank lid
• Connect suction pipe to lid from
not assembled
milk tank
• The appliance is overheated
• Switch appliance off untill it is
cooled down. Then switch on
again. If button B still flashes fast
contact service center.
• Environment is too cold.
• Place the appliance to room temp
Less than 5 degree °C
environment. If button A still fla-
shes fast contact service center.
254 x 360
mm
3,34
kg
220-240
V
50 - 60
Hz
1000
W
1,5
m
600
ml
600
ml
9
10
11
GB
13
Publicité
