Introduction; Description Of Accessory; Operation Of The Accessory - AERMEC VMF-485LINK Manuel D'utilisation

EN
1.

INTRODUCTION

1.1.

Description of accessory

The VMF-485LINK expansion was developed to interface and make the following units compatible with
the VMF communication protocol:
• HMI (monobloc heat pump)
• BHP (split heat pump)
• FCWI (fancoil inverter for wall installation)
1.2.

Operation of the accessory

The VMF-485Link accessory allows the communication and it-
eration of the VMF-E5/E6 supervisors with the heat pumps of
the HMI and BHP series and with the fan coils of the FCWI series.
This accessory can also be used with the Multicontrol controller
for the management of HMI and BHP heat pumps.
The accessory, as identified by the general layout, has two dis-
tinct serials:
• MASTER (to terminal M2): this serial connects directly to
the element to be inserted in the VMF network
• SLAVE (to terminal M3): this serial interfaces with the VMF
network where you want to insert the element
The internal logic of the VMF-485Link gateway allows Aermec
or third-party supervisors to control FCWI fan coils such as
VMF-E19 thermostats and to manage HMI/BHP heat pumps
such as the external units of the ANL/ANK/ANKi series.
16
VMF network supervisor
VMF network element
VMF (n) network element
VMF-AER485LINK
FCWI
VMF-AER485LINK
HMI
VMF-AER485LINK
BHP
VMF network general layout
M2 M3
M2 M3 M2 M3
M2 M3 M2 M3