Publicité
Les langues disponibles
Les langues disponibles
26
Vestfrostsolutions.com
MAINTENANCE
TASK
The compressor com-
partment and the con-
denser must be kept
free of dust and dirt.
The door gasket around
the door must be
cleaned regularly.
Clean vacuum release
Perform a temperature
calibration at least once
a year.
Replace the battery
backup for the control-
ler every 3 years.
Clean the interior and
exterior of the device.
Description
1. Unplug unit from power supply
2. Remove the lower panel.
3. Use a vacuum cleaner to remove
dust and dirt.
1. Wipe the seal with a soft cloth
and clean water
2. Check that it continues to provide
a tight seal.
1. Excessive frost accumulation in
the vacuum release could restrict
air flow.
2. Brush away any loose frost using
a stiff nylon brush.
3. If frost has built up in the pipe of
the vacuum release, thrust with a
stick to remove the frost inside.
Only a certified technician must
make the calibration.
Only a certified technician must
replace the battery.
1. Use warm water (max. 65°C)
with a little mild, perfume-free
detergent with a soft cloth.
2. Rinse with clean water and dry
thoroughly.
Note: It is important to prevent wa-
ter from entering the control panel.
Frequency
Quar-
An-
terly
nual-
Years
ly
X
X
EN
3
As
ned-
dede
X
X
X
X
Publicité
