Publicité
Les langues disponibles
Les langues disponibles
8. Operation
8.1. Start satellite
• Make sure that the water and air supply to the
unit is open, see layout drawing. In case of cen-
tral chemical supply this must be activated too.
• Select requested function. Use the unit according
to the "User Guide".
•
Never activate the spray handle while using the
switch to select a function.
8.2. Stop satellite
• Close the water supply (layout drawing).
• Close the air supply (layout drawing).
• Deactivate chemical supply by pulling up the suc-
tion hose or removing the userpack. In case of
central chemical supply this must be deactivated
too.
It is important to shut off the water and
air when the unit is left after use .
If the air supply is open when the unit are not in use,
air may seep into the water pipe. If this is the case
the system may have to be bled again.
It may be necessary to bleed the pipes and the unit
again after it has been closed for a longer period of
time (holidays, and the like).
8.3. Rinsing the chemical supply/injector system
CAUTION
The chemical supply must always
be rinsed thoroughly after use
Remains of detergents or disinfectants can clog the
injector so it needs to be rinsed or replaced.
The following procedure will clean the chemistry
supply for detergents and/or remains of disinfectants
• Remove User Pack or standard can
• Insert a User Pack or can containing clean water.
In case of a can make sure the suction hose is
submerged in water.
• Open the spray gun/outlet valve and keep it open
until the injector has been rinsed through (ap-
prox. 30 seconds).
This procedure should be
followed both on the detergent
and the disinfectant side (if this is
installed).
18
Publicité
