Publicité
Les langues disponibles
Les langues disponibles
Screws and nuts
In a moving environment, screws and nuts must be tightened properly. An easy way
to lock a screw is to use ordinary fingernail polish. A big advantage of nail polish is that
you always can loosen it quite easily again.
The size of a screw is expressed by thickness and length. A screw with the marking M2 x 10
means 2 mm thick. The length of the thread is 10 mm. A M2 nut is used for a M2 screw, so the
E E
nut always corresponds with the screw thickness mm.
N N
G G
Wrench:
L L
I I
S S
H H
Impressum
©2023 AREXX Engineering
Nervistraat 16
8013 RS Zwolle
The Netherlands
Tel.: +31 (0) 38 454 2028
Fax.: +31 (0) 38 452 4482
E-Mail: Info@arexx.nl
Information about limited warranty and responsibility
The warranty granted by AREXX Engineering is limited to the replacement or repair of the
product and its accessories within the legal warranty period if the default has arisen from
production errors such as mechanical damage or missing or wrong assembly of electronic
components except for all components that are connected via plugs/sockets.
The warranty does not apply directly or indirectly to damages due to the use of the product.
This excludes claims that fall under the legal prescription of product responsibility.
The warranty does not apply in case of irreversible changes (such as soldering of other com-
ponents, drilling of holes, etc.).The warranty is not applicable in case of disrespect of this
manual! In addition, AREXX Engineering is not responsible for damages of all kinds resulting
from the disrespect of this manual!
IMPORTANT
Be sure you read the warnings before you start!
Thickness
Length
This kit includes a
small wrench. Please
use this wrench
to fit the nuts in a
proper way. You can
use it instead of a
plier.
This manual is protected by laws of Copyright. Any full or partial
reproduction of the contents are forbidden without prior
written authorization by the European importer.
Product specifications and delivery contents are subject to chan-
ges. The manual is subject to changes without prior notice.
You can find free updates of this manual on
http://www.arexx.nl/
Nut
Do not tighten the screws too tight,
otherwise the parts will break.
- 5 -
Self-tapping screws
Publicité
