Publicité
Les langues disponibles
Les langues disponibles
Connect Electrical Supply
WARNING
9
RISK OF ELECTRIC SHOCK
Before wiring the appliance, interrupt the main
electrical circuit at the electrical control cabinet. A
circuit with 120 VAC, 15 or 20 Ampere is required.
Grounding notes: this appliance is equipped with a
distributor box with 3 cables. Use the green-yellow
cable for grounding the appliance. Connect the
green-yellow cable to the grounding cable on the
house connection to prevent electric sthock. Do not
under any circumstances damage or remove the
green-yellow cable. Non-adherence can cause
deadly injuries or electric shock.
Remove the left cable passage and the cover of the
1.
motor controller. Fasten the connecting piece for the
installation pipe (listed in cULUS) to the cable
passage.
A
Cable passage
B
Cover of the motor controller
Connect 1/2" (12.7 mm) installation pipe to motor
2.
controller.
A
Installation pipe
B
Power connection
C
Cable connector listed in UL
12
Attaching flue duct
Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.
Remove the protective foil from both flue ducts.
1.
Push one flue duct into the other.
2.
Notes
To prevent scratches, lay paper over the edges of
▯
the lower flue duct to protect the surface.
For ducted operation, turn the upper flue duct so
▯
that the ventilation slots point downward.
Remove the protective foil from the extractor hood.
3.
Place flue ducts on the appliance.
4.
Push the inner flue duct upwards and attach it to the
5.
angle brackets on the left and right.
Screw the flue duct to the sides of the angle bracket
6.
using two screws.
A
Upper flue duct
B
Lower flue duct
C
Screws
D
Angle bracket
Publicité
