Publicité
ENGLISH
GETTING STARTED
CHARGING YOUR APPLIANCE
•
Ensure the product is switched off.
•
Connect the charging adaptor to the product and then to the mains.
•
If the product is not going to be used for an extended period of time (2 – 3 months),
unplug it from the mains and store.
•
Fully recharge your hairclipper when you would like to use it again.
•
Allow 14-16 hours for a complete charge.
•
When charging the LED indicator will be illuminated and will remain illuminated once
the product is fully charged.
CORDED USE
Connect the charging adaptor to the product then to the mains.
CAUTION Extended mains only use will result in the reduction of the battery life.
CORDLESS USE
When the unit is switched on and fully charged, the product can be used in cordless mode
for up to 40 minutes.
INSTRUCTIONS FOR USE
BEFORE STARTING THE CUT
•
Inspect the clipper making sure that it is free from hair and dirt.
•
Seat the person so that their head is approximately at your eye level.
•
Before cutting, always comb the hair so it is tangle free and dry.
TO ATTACH A COMB
•
Hold the comb with its teeth upward.
•
To attach a comb, align the legs of the comb with the holes in the top of the clipper on
each side of the blade and slide the legs into the trimmer until they click.
•
To remove, firmly pull the comb straight up away from the clipper.
HAIR CLIPPER COMB SETTINGS
•
The clipper comes with two adjustable combs, a short length adjustable comb
(indicated by 1-21mm on the back of the comb) and a longer length adjustable comb
(indicated by 24-44mm on the back of the comb).
•
Please see table below for different cutting lengths available on each comb.
4
Publicité
