Maxi-Cosi Pebble 360 Pro Mode D'emploi page 79

EN
• Only use the newborn inlay of the Pebble 360 Pro/
Pro² until your baby exceeds the 60 cm length limit.
Afterwards remove the newborn inlay from the Pebble
360 Pro/Pro².
WARNING:
• Never place the car seat on an elevated surface (such
as a table or chair).
• It is prohibited to adjust the seat position while
travelling.
Using Pebble 360 Pro/Pro²
• When Pebble 360 Pro/Pro² is installed on a stroller,
always make sure to use approved car seat adapters
and to secure Pebble 360 Pro/Pro² correctly.
• The height of the headrest and the shoulder harness
can be set simultaneously into different positions. Pull
the headrest adjustment strap and meanwhile, pull
up or push down the headrest until it's in the correct
position.
Pebble 360 Pro/Pro² in airplanes
• Installation of the Pebble 360 Pro/Pro² on an aircraft
seat differs from the installation on a car seat.
• Installing the Pebble 360 Pro/Pro² with a 2-point
safety belt is only allowed when used in an aircraft.
• In an aircraft, the Pebble 360 Pro/Pro² may only be
used on forward-facing passenger seats.
• To install Pebble 360 Pro/Pro², place the infant carrier
rearward facing on the passenger seat.
Route the webbing of the-2point safety belt through
the belt guides. (1,2)
Lock the buckle of the 2-point safety belt. (3)
And tighten the 2-point safety belt by pulling on the
tightening strap. (4)
• The handle of the Pebble 360 Pro/Pro² must be in
upright position.
• The belt buckle must not be positioned between
the belt hooks of this car seat. Otherwise a safe
attachment does not exist.
I
79 Pebble 360 Pro/Pro 40-87cm / max. 13 kg
2
I
Maxi-Cosi
• To uninstall Pebble 360 Pro/Pro², open the buckle
of the 2-point safety belt by lifting the lever of the
buckle. (5)
And remove the webbing of the 2-point safety belt
from the guides. Make sure the Pebble 360 Pro/Pro²
does not fall from passenger seat when opening the
buckle.
• The Pebble 360 Pro/Pro² must remain belted on the
aircraft seat, even when unoccupied.
• The Pebble 360 Pro/Pro² is only for use on an aircraft
seat authorized by the airline.
• Do not install the Pebble 360 Pro/Pro² in the area of
airbag deployment.
• Instructions of the cabin crew must be followed.
• The safety of your child for not complying with the
installation and instruction manual is not guaranteed.
CARE
• The cover, inlay, belt pads and sun canopy of the car
seat can be removed for washing. The front baleen of
the sun canopy needs to be removed before washing.
The harness webbing can be cleaned by using a wet
cloth.
• The plastic inserts of the shoulder pads do not need
to be removed before washing.