Ergomotion Rio 3.0 Manuel De L'utilisateur page 4

Safety precautions and usage statements
This is normal. During operation, the lift arm wheels make contact with the
platform support of the base. This contact may result in metal on metal or
metal on plastic contact. This applies slight tension on the moving components
and resonance is reduced to a minimum level. If excessive noise or vibration is
experienced, reverse the movement action (up or down) of the base with the
remote control. This should realign the base's activating mechanisms to the
proper operational position. In normal base operation, the wheels, which allow
the bed to maintain its distance from the wall, will make contact with the steel
platform supports of the base creating a contact noise. When entering, exiting
or shifting weight on the base, this contact noise may be audible as the wheels
make contact. This is normal.
MATERIALS
Ergo adjustable bases are constructed from various materials including woods,
metals, plastics and fabrics. Tension, pressure or movement applied to the
frame, platform or shroud through general use may create an audible sound.
TOLERANCE
All Ergo adjustable foundations, depending on make and model, are designed
and manufactured to perform and function within designated quality control
parameters. Bases are subject to meticulous and rigorous inspections during
the quality control process to ensure bases will operate within these standards
during normal operating use. Normal operating use is defined as the following:
Adjustable foundation is to be
operated with a mattress and
load. Testing procedures require
lifetime cycle tests with up to
120kg distributed load. The
angle (designated "α" in figure
1) between the back section
and the flat section for various
configurations of the mattress
support platform shall be ± 3°,
which translates to a tolerance of
up to 1 ½".
The angle (designated "β" in figure 1) between the flat section and foot section
for various configurations of the mattress support platform shall be ± 3°, which
translates to a tolerance of up to ¾".
2
Any adjustable foundation deemed to be within these allocated tolerances is
considered to have met the manufacturer's quality control standards.
THAT "NEW PRODUCT" SMELL:
Some people notice a slight odor to their new adjustable base—this can come
from our material manufacturing process. This smell is normal and usually
disappears before the product reaches you. Sometimes, however, this smell may
still be noticeable. It usually disappears after a few weeks, providing adequate
ventilation of the product and the environment.
BREAK IN PERIOD:
You can speed up the break-in period by simply spending time in the adjustable
bed through activities such as reading, watching TV or playing with the kids or
grandkids. The extra movement will help the adjustable base respond to weight
and temperature changes. Some of the materials in our adjustable bases such
as the woods, metals and plastics used in the platform, frame and components
are sensitive to moisture content and temperature and may make sounds in
colder environments.
PAIRED OPERATION:
When operating a "paired" split base setup there may be a time latency up to
1.5 seconds between each bases articulation.
WEAR AND TEAR:
Wear and tear is damage that naturally and inevitably occurs as a result of
normal use or aging.
FABRIC CARE:
To prolong the life of your fabric, protect from direct sunlight whenever
possible. For spot cleaning, wipe area with a light damp sponge or vacuum with
a soft brush attachment to remove particles. Keep at a minimum of 30cm (12
inches) away from direct heat sources. For a deeper cleaning, blot liquid spills
with a clean dry cloth. Wipe with a clean cloth dampened with warm water.
Do not wet excessively. A soft bristle brush may be used to remove ingrained
soil. Avoid scratching by gentle brushing. Wipe with a clean cloth dampened
with warm water to remove residues. Dry in shade away from direct heat. If
persistent marks remain visible after cleaning, seek professional advice.