Publicité
Les langues disponibles
Les langues disponibles
Headboard bracket installation guide (optional)
Headboard Brackets are an optional accessory and are not included.
A hex key is included with the accessory kit to complete installation.
STEP 1
a. Align the hole in the bracket to the brass sleeve into which the leg
threads. Hold the bracket in place and screw the leg into the base until it
is snug. DO NOT OVERTIGHTEN. Too much force may cause the leg to spin
freely.
b. Align the tab with the hole in the frame (located towards the foot of the
base) and use a short bolt, washer and wingnut to secure the bracket.
Make sure the bolt is tight.
STEP 2
a. Measure the distance between the mounting holes on the headboard
and install the T-Bracket to accommodate the headboard.
b. To install the T-Bracket, slide the T-Bracket through the end of the
headboard bracket. Align the flat side of the T-Bracket plate to the
mounting holes on the headboard.
c. Secure T-Bracket in place by inserting two short screws through top of
bracket. Use hex key to tighten screws.
STEP 3
Connect your headboard to the attachment plate using the remaining long
screws or hardware that came with your headboard. The heads of the bolts will
face outward. Use hex key to tighten bolts.
13
Publicité
