Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Setting the Torque
The fastening torque can be adjusted in 20+1 settings by turning the adjusting ring
1
so that its graduations are aligned with the pointer on the tool body.
1. Adjusting ring
2
2. Graduations
3
3. Pointer
The fastening torque is minimum when the number 1 is aligned with the pointer.
and maximum when the
various torque levels when set at the number 1 to 21.
Before actual operation, drive a trial screw into your material or a piece of duplicate
material to determine which torque is required for a particular application.
Gear Selection, Mechanical
Actuate the gear selector (4) only when the tool is at a standstill.
Two speed ranges can be used with the gear selector (4).
Gear 1:
Low speed range (0-400 RPM); for screwdriving or working with large drilling diameter.
Gear 2:
High speed range (0-1300 RPM); for working with small drilling diameter.
If the gear selector (4) cannot be fully engaged, lightly rotate the driver spindle with
the drill bit by twisting the drill chuck.
Adjusting the Speed
The speed of the switched on power tool can be variably adjusted, depending on
how far the On/Off switch (7) is pressed.
Light pressure on the On/Off switch (7) results in a low rotational speed. Further
pressure on the switch results in increased speed.
Fully automatic spindle locking (Auto-lock)
When the On/Off switch (7) is not pressed, the drill spindle and thus the tool holder
are locked.
This enables screws to be screwed in, even when the battery is empty and allows
for the tool to be used as a screwdriver.
Run-on Brake
When the On/Off switch (7) is released, the chuck brakes to a stop, thus
preventing the run-on of the tool.
When driving in screw, wait until the screw is screwed in flush with the material
and then release the On/Off switch (7). By doing so, the head of the screw does
not penetrate into the material.
Operating Instructions
Apply the power tool to the screw only when it is switched off. Rotating tool inserts
can slip off.
Soft Grip
The gripping surface (soft grip) (8) reduces the danger of slipping and thereby
improves the grip on the tool and the handling.
At the same time, the rubber coating achieves a vibration-reducing effect, for an
increased comfort for the operator.
Screwdriving operation
First, slide the action mode change lever to the position of
fastening torque.
Place the point of the driver bit in the screw head and apply pressure to the tool.
Start the tool slowly and then increase the speed gradually. Release the switch (7)
as soon as the clutch cuts in.
symbol is aligned with the pointer. The clutch will slip at
symbol and select the
23
Publicité
