Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
Battery Charging
To charge your tool`s battery,use only charger and battery
pack(model:B0P-SP18-14;B0P-SP17-18) provided with your tool. Using other
batteries can lead to injuries and pose a fire hazard. Details as per battery charger
manual.
WARNING! Do not continue to press the On/Off switch after the tool has been
automatically switched off. The battery can be damaged.
The battery is supplied partially charged. Completely charge the battery before
using your power tool for the first time. The battery can be charged at any time
without reducing its service life. Interrupting the charging procedure does not
damage the battery.
a) Always switch off the tool before insertion or removal of the battery pack.
b) To insert the battery pack(10), align the tongue on the battery pack with the
groove in the housing and slip it into place. Always insert it all the way until it
locks in place with a little click. If not, it may accidentally fall out of the tool,
causing injury to you or someone around you. (Pic.(a))
c) To remove the battery pack(10), by pressing the battery unlocking button (9)
on both sides and pulling the battery out of the power tool toward the rear.
d) Do not use force when inserting the battery pack. If the pack does not slide in
easily, it is not being inserted correctly.
Changing bits
CAUTION! Always be sure that the tool is switched off and the battery pack is
removed before carrying out any work on the tool.
1) Hold the ring and turn the sleeve counter-clockwise to open the chuck jaws.
Place the bit in the chuck as far as it will go.
2) Hold the ring firmly and turn the sleeve clockwise to tighten the chuck.
3) To remove the bit, hold the ring and turn the sleeve counter-clockwise.
OPERATION
Starting Operation
Switching on:
To start the tool squeeze on the On/Off switch(7) and then keep it pressed down.
Switching off:
To stop the tool, release the On/Off switch (7).
Reversing the Rotational Direction
This tool has a reversing switch to change the direction of rotation. Push the
reversing switch lever from the left (2) side for clockwise rotation or from the right
(3) side for counterclockwise rotation.
When the reversing switch lever is in the neutral position, the switch (7) cannot be
pulled.
22
!
!
1
2
1
L
R
3
2
Publicité
