Publicité
Les langues disponibles
Les langues disponibles
ADDITONAL SAFETY WARNINGS
17) If you wish to charge a second battery pack, unplug the charger from the
mains supply and leave it for at least 15 minutes. After this time you can
charge a second battery pack.
3. Important safety instructions for battery pack
1) The battery pack for this tool has been shipped in a low charge condition.
You should charge the battery pack fully before use.
2) To ensure the longest battery life and best battery performance, always
charge the battery when the air temperature is between 18-24ºC (65-75ºF).
Do not charge the battery pack when the temperature is below 4ºC
(40ºF),or above 40ºC (104ºF). This is important. Failure to observe this
safety rule could cause serious damage to the battery pack.
3) Do not incinerate the battery pack even if it is seriously damaged or can no
longer hold a charge. The battery pack can explode in a fire.
4) A small leakage of liquid from the battery pack may occur under extreme
usage or temperature conditions. This does not necessarily indicate a
failure of the battery pack. However, if the outer seal is broken and this
leakage comes into contact with your skin, wash the affected area quickly
with soap and water. Neutralize the liquid with a mild acid such as lemon
juice or vinegar; If the leakage gets in your eyes, flush your eyes with clean
water for a minimum of 10 minutes and seek immediate medical attention.
Inform the medical staff that the liquid is a 25-35% solution of potassium
hydroxide.
5) Never attempt to open the battery pack for any reason. If the plastic
housing of the battery pack breaks open or cracks, immediately discontinue
its use and do not recharge it.
6) Do not store or carry a spare battery pack in a pocket, toolbox or any other
place where it may come into contact with metal objects. The battery pack
may be short circuited causing damage to the battery pack, burns or a fire.
7) The battery pack utilizes nickel-cadmium cells. Cadmium is considered to
be a toxic material.
8) Use an environmentally safe disposal unit at a municipal waste disposal
centre to dispose of a damaged or worn out battery, or return it to your
dealer.
APPLICATIONS
Intended Use
The tool is intended for driving in and loosening screws as well as for drilling in
wood, metal, ceramic and plastic.
Check-the delivery parts
Carefully remove the tool from its packaging and check as the following parts are
complete:
--Cordless drill driver
--2 pcs rechargeable battery packs
--Battery charger
--Any other accessories (bit etc)
--Instruction manual
If anything is missing, or broken, please contact Customer Service at
1-866-206-0888.
20
Publicité
