HOLZMANN MASCHINEN MABS 750 Mode D'emploi page 25

14.2 Cleaning
After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal surfaces as
well as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution
14.3 Disposal
Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
15 TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT
THE MACHINE FROM THE POWER SUPPLY.
Trouble
The magnetic support has no
magnetic force
Dust emerges from
Loud noise in the fan wheel
housing
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you
have not the prescribed training for it always attract a workshop to fix
the problem.
HOLZMANN MASCHINEN GmbH
Possible cause
 Switch defective
 Power supply is off
 Fuse is defectivet
 Electric contactor is defective
 Leaking or blocked
connections
 Chip drawer or filter bag is
defective or incorrectly installed
 Extracting of a big part
 Loosen fan wheel
www.holzmann-maschinen.at
N O T I C E
 Repair switch
 Repair power supply
 Change fuse
 Repair or change electric
contactor
 Check connection
 Remove blockages
 Check bags
 Change defective bags
 Switch of the machine,
disconnect the machine and
remove the part
 Tighten the fan wheel
N O T I C E
TROUBLE SHOOTING
Solution
25
MABS 1500