Siemens GI81NAE30 Notice D'utilisation page 26

en Installation and connection
Using the appliance
Open the appliance door only briefly.
Transport purchased food in a cool bag and place
quickly in the appliance.
Allow warm food and drinks to cool down before
placing in the appliance.
Thaw frozen food in the refrigerator compartment in
order to utilise the low temperature of the frozen
food.
Always leave a space between the food and the rear
panel.
Pack food airtight.
Vacuum the back of the appliance once a year.
Do not cover or block the ventilation openings.
--------
Before using your appliance
for the first time
Remove leaflets, adhesive tape and
1.
protective film.
Clean the appliance.
2.
~ "Cleaning" on page 32
Electrical connection
Caution!
Do not connect the appliance to
electronic energy saver plugs.
You can connect the appliance
Note:
to mains-controlled and sine-controlled
inverters.
Mains-controlled inverters are used for
photovoltaic systems which are
connected directly to the national grid.
Sine-controlled inverters must be used
for isolated applications. Isolated
applications, e.g. on ships or in
mountain lodges, which are not
connected directly to the national grid.
26
The air in the appliance does not warm up so
intensely. The appliance must cool less frequently
and therefore consumes less power.
The air can circulate and the air humidity will
remain constant. The appliance must cool less fre-
quently and therefore consumes less power.
The air on the rear panel of the appliance does not
warm up so intensely. The appliance consumes less
power if the warm air can escape.
After installing the appliance, wait at
1.
least 1 hour before connecting it to
prevent damaging the compressor.
Connect the appliance via a
2.
correctly installed socket.
The socket must comply with the
following data:
Socket with
Conductor
Fuse
Outside Europe: Check whether the
indicated current type of the
appliance corresponds with the
values of your power supply.
Appliance specifications are on the
rating plate.
~ "Getting to know your appliance"
on page 27
Connect the appliance to a socket
3.
near the appliance.
The socket must be freely
accessible even after the appliance
has been installed.
220 V ... 240 V
50 Hz
10 A ... 16 A