Connection - Renkforce 751624 Notice D'emploi

6.2 Connection

7) "Reset" Jumper
For resetting the lock to factory settings (see chapter "8.8. Restore factory settings
(RESET)").
8) Sabotage Contact
Is triggered as soon as the housing cover is lifted.
9) "Door Magnet Contact" Jumper
This jumper must be removed as soon as a door magnet contact is connected to the
"door magnet contact connection" (circuitboard label = REED).
26
1) "Lock Out" Relay Contacts
2) "12-24 V (AC/DC)" Connection
3) Alarm Outlet (-)
For connecting an alarm siren. (=nega-
tive switched; circuitboard label = "AL
OUT(-)")
4) "Egress" Connection (P.B.)
An NO sensor can be attached here
which can activate the "Lock Out" relay
contacts.
5) "Door Magnet Contact" Connection
For connecting a door magnet contact
NC). Circuitboard label = REED
6) "Aux Out" Relay Contacts