Normal Operation - Jacob Jensen T50 Manuel D'utilisation

5. Press / to display either "On" or "Off" and
press to confirm. For "Key", select from
"Pattern 1-3" or "Off" and press
6. Press to exit and return to standby mode.
d .6 . diAl mode
You can set your phone to use either "Tone" or "Pulse"
dialing. The pre-set setting is "Tone" dialling, where you
will hear a tone beep each time you dial a number. Most
modern exchanges and switchboards use "Tone" dialling, so
you should not need to change this setting. Only change it if
your service provider or switchboard uses "Pulse" dialling.
Key Map:
Setting base
Mode select tone/pulse
1. Press to access the main menu.
. Press / to select "Setting Base". Press
3. Press / to select "Additional". Press
4. Press / to select "Dial Mode".Press
The current setting is displayed.
5. Press / to select either "Tone" or "Pulse".
Press to confirm.
6. Press to exit and return to standby mode.
d .7 . tone dialling Switch-over
If you have set your phone to use "Pulse" dialling, you can
switch temporarily to "Tone" dialling for the duration of a
call:
During off-hook state, press and hold
displayed. Any digits entered after the "D" will be dialled
using tone dialling.
d .8 . prefix dialling
If you need to add a prefix to the number for a long distance
call, or if you need to add your saved area code to the
number, do the following:
Key Map:
Setting base
prefix dial enter the number
1. Press to access the main menu.
. Press / to select "Setting Base". Press
3. Press / to select "Additional". Press
Additional dial
"D" will be
Additional
4. Press /
The current setting is displayed.
5. Enter the number using the number keypad or press
to clear. Press
6. Press to exit and return to standby mode.
d .9 . Call barring
When switched on, Call Barring prevents calls from being
made to a specific number, area code or international code.
Key Map:
Setting base
enter the number
1. Press to access the main menu.
. Press /
3. Press /
4. Enter the number using the number keypad or
clear. Press
5. Press /
. to confirm.
6. Press to exit and return to standby mode.
E .

norMAl opErAtion

E .1 . using an optional headset
An optional headset can be used as an alternative method to
make a call and this is especially useful for long calls.
Connect the headset cord to the headset jack on the back of
the base unit. When the headset is not in use, simply press
the button to toggle the headset mode and return to
normal handset or speaker phone mode.
Caution
The headset jack type is .5 mm pin. Please contact your
local supplier for compatible headset. Using other headsets
may damage the unit.
E .2 . to make a call
Using the handset:
1. Pick up the handset. The display will show the handset
icon .
. Use the keypad to enter the number you wish to dial.
3. Hang up the handset when finished.
to select "Prefix Dial".Press
to confirm.
Call barring
select on/off
to select "Setting Base". Press
to select "Call Barring". Press
to confirm.
to select "On" or "Off". Press
.
to
13