Publicité
Les langues disponibles
Les langues disponibles
LIGHT OPERATION INSTRUCTIONS
WARNING
Do not let the electrical supply cord hang over the
Ÿ
edge of a table or touch any heated surface.
Use the shortest length extension cord required.
Ÿ
Do not connect 2 or more extension cords
Ÿ
together.
To protect against electrical shock, do not
Ÿ
immerse cord or plugs in water or other liquid.
Unplug from the outlet when not in use and before
Ÿ
cleaning. Allow to cool before putting on or
taking off parts.
Do not operate grill with a damaged cord, plug or
Ÿ
after the appliance malfunctions or has been
damaged in any manner. Contact the
manufacturer for repair.
Do not use an outdoor cooking gas appliance for
Ÿ
purposes other than intended.
When connecting, first connect plug to the
Ÿ
outdoor cooking gas appliance then plug
appliance into the outlet.
Never remove the grounding plug or use with an
Ÿ
adapter of 2 prongs.
Use only extension cords with a 3 prong
Ÿ
grounding plug, rated for the power of the
equipment, and approved for outdoor use with a
W-A marking.
IMPORTANT
Since 1971 the National Electrical Code (NEC) has
Ÿ
required Ground Fault Interrupter devices on all
outdoor circuits.
If your residence was built before 1971, check with
Ÿ
a qualified electrician to determine if a Ground
Fault Interrupter (GFI) protector exists.
Do not use this appliance if the circuit does not
Ÿ
have GFI protection.
Do not plug this appliance into an indoor circuit.
Ÿ
10
Light Operations
1. Make sure light switch on the control panel is in the "OFF" position.
The button should be flat with the rim.
2. Connect the light plug to a GFI outlet or an extension cord, then put
the extension cord plug into the outlet on the wall.
Light plug
3. Turn the light switch to "ON" by pressing the button. Turn "OFF"
by pressing the button again.
OFF POSITION
Extension cord,
for outdoor use
ON POSITION
Publicité
