Publicité
Les langues disponibles
Les langues disponibles
5. Locate the hydraulic hose fitting on the hose
assembly (45). Install the O-ring (9) into the
groove of the hose connection fitting (45). Then
Connect the hydraulic hose (45) to the gauge (13).
Securely tighten the hose fitting (45) on the gauge
(13).
13
6. Insert the cylinder assembly (2) from the top side
of frame. Once the cylinder is inserted intothe
cylinder base (8) make sure that the roundlifting
ring is seated flat on the cylinder base (8). Then
attach the round nut (R2) to the cylinderassembly.
Turn clockwise to screw the roundnut (R2) onto
threaded shaft on the ram. Tightenround nut (R2).
8
45
9
10
2
R2
7. Connect the male coupling hose connector (45) to
cylinder assembly (2).
45
8. Carefully bring the lower bolster (19) up and
secure it with support pins (21) and round wire
snap rings (20).
21
20
9. Place the bolster plates (18) on lower bolster (19).
7
2
19
19
18
Publicité
