Trebs Comfortair Mode D'emploi page 29

5.1 Operation
Warning: before filling the unit with water, turn the power off and unplug unit from the outlet.

Place the body horizontally at a suitable place.

Take the water tank out and turn the tank over. Screw off the tank cover as indicated by the arrow
at "Add Water Here" and insert clean tap water.

Close the water tank, wipe off water drops around the water tank and place the water tank
properly.

Before opening the product, please insert the water filter in the base at the circular recess.

Connect the unit to an AC power supply, touch the
function. Press this button again to turn the device off.

Humidification button: while operating, you can touch the
need. There are 3 programs: " Light humidification" "Middle humidification" "Strong
humidification". The device can cycle through these programs.

Thermal mist button: touch the
heated. This will enhance the wetting effect. Touch the button again to stop heating.

Timing function: touch the
cycle selection. Choose to " CH " hours and then cancel this function .

Automatic humidistat: touch the
display will show the available moisture percentages. Choose the moisture percentage you want
and confirm the operation after 3 seconds. If you want to cancel this function, you can select the
current ambient humidity.

Sleep button: touch the
humidification on the humidity in the room. The humidity will be maintained in the range of 65-
70 %.If the humidity in the room is higher than 70%, the device will enter the power saving state
and the tank nightlight will turned off. If the air humidity is below 65%, the device will
automatically re- operate. Touch this button again, to turn off this function.

Strong humidification and Purification function: Touch the
This function can be used to achieve strong humidification. If this function is activated the green
indicator light will light up. The device quickly starts the air humidification, filtration and
purification.
If this function is activated the air will be filtered of dust , bacteria, nicotine and other harmful
substances because of the release of a large number of negative ions. Press the
to cancel the function.

If the water tank is empty, the built-in safety device will disconnect the atomization circuit
button to start the hot mist function. The cold water will be
button to enter the timing options. The time range is 1-9 hour
button to enter the automatic humidistat option. The
button to activate the sleep function. The device will base the
button and open the humidification
button to select the mist you
button to start the purification.
button again
29