Operating Precautions; Safety Precautions - Trebs Comfortair Mode D'emploi


Before cleaning or moving the unit, shut the device down or disconnect the plug.

When the unit is operating ,do not touch the water in the water bath or any part in the water

Do not operate the unit with an empty water bath.

Do not scratch the ultrasonic oscillator with a hard object.

Do not clean the transducer with a cleaning agent not manufactured or whose manufacture is
supervised by our company.

Do not let water flow or splash into the base to avoid damaging the internal parts.

Pay attention to the environment of installation:
- Put the unit at a firm and flat place, avoid inclination and keep it steady.
- Place the unit away from any heat source, such as a furnace ,avoid direct sunlight.
- Place the unit away from furniture and electric appliances. Avoid direct spraying of mist
onto the furniture and electric appliances, otherwise they will become damp or attached
with "white powder"
- Place the unit in normal room temperatures. Avoid operating the unti in chilly environments
to avoid damage to the unit. If there is freezing inside, do not start unit until the ice has
been cleared or melted

2.3 Operating Precautions


Do not add hot water of above 40℃ to the water tank and water bath to avoid discoloration or
distortion.

Do not let water flow into the body from the air outlet. Wipe off any water outside the body with
dry cloth.

If the room temperature is below 0℃,please empty the water tank and water bath, lest the icing
of water should damage the components.

Do not place metals, chemicals and detergents into the water bath, otherwise there might be
poor atomization.

If there is much water in the water bath, do not move it about, otherwise water might overflow
and flow into the body

Do not put the unit at a place with strong light or direct hot air radiation.

Do not place the unit near an open window and try to keep the device away from furniture and
electric appliances.

Do not add water into the water bath directly.

If the unit is not to be used for a long time, please cut off the power and unplug the plug(this unit
does not have to be grounded).

Never pour out the water remaining in the water bath without the power turned off, otherwise
the transducer will be burned out immediately.

If the water tank is fully loaded, the unit can operate for 7-12 hours continuously without
replenishment.

2.4 Safety Precautions


Do not turn on the plug with a wet hand, there might be a risk of an electric shock.

If the body is inclined, please handle this with the power cut off.

Do not touch the transduction piece upon starting.

Do not disassemble the unit without cutting off the power to avoid an electric shock.

Do not replace the power cord without authorization.
25