Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTION FOR USE
INSTRUCTION FOR USE
Attention! Before the fi rst use of the device you must wash the device with cleaning cloth dipped in the water
with detergent. Than wipe it with moist cleaning cloth dipped in clean water.
Fill the device with water to the high of max 2 cm. Switch on with main switch (B) turn the knob (A) from the
position „0" to required position between 30°C - 90°C. Pilot lamp indicates that the device in on. Pilot lamp
(C) lights when thermo spirals are on. Pilot lamp (D) goes out when the device reaches required temperature.
Switch the device off by turning the knob (A) into position „0" and switch over the switch (B) into position
switched off . Check the level of the water, never use the device without water. Use the device under supervision.
The device must be fully occupied with the gastrobowls. If the bains are not fully occupied with the gastro
bowls, you must cover the empty spaces with the gastro covers to prevent escape of the warm and water
steam. In each models there is separate handling for each bain. If you do not use the device for longer time
remove the main cabel (D) from the electricity net and give this in the side-hole on the panel of the device.
If you place the moving models it is necessary to brake thein wheels. By standing models, you must fi x them
with regulation legs.
• safety fuse of the feeder and inner mains can stand the loading of the device (see label of the matrix)
• mains are equipped with eff ective grounding according to standards (ČSN) and conditions given by law
• socket or switch of the feed is well accessible from device
We refuse any responsibility in case of not respecting above mentioned rules. Before the fi rst use it is
necessary to remove all the protection foil and to clean the device - see chapter „cleaning and maintenance".
Maintenance: We recommend to have the device checked once a year by the proff esional service. Only
qualifi ed or competent persons can do interventions in the product.
B
C
A
E
F
DISCHARGING OF THE BATH
Discharge the bath when the water is cold and the device is disconnected from the electricity. User must have
convenient bowl for discharging the bath.This bowl must be made from heat-resistantmaterial. Put the bowl
in the safe place to prevent discharging water from splashing. Splashing can cause the danger. Put on the
dischargingpipe, open the safery catch by turning it up and turn the lever into position marked as opening of
the cock. Discharge the bath only when the water is cold.
7
7
A
REGULATION KNOB
B
MAIN SWITCH
C
LED
E
OUTLET VALVE
F
VALVE LEVER
Publicité
