Publicité
LINE OUT 1 + 2
8
Analogue line outputs with balanced terminal block connections. The poles +, - and G are intended
for the balanced output signal (suitable for unbalanced cabling). Terminal blocks are included in the
packaging content.
VCA
9
Terminal block connection for connecting an external volume control for continuously variable attenuation
of the mix volume at the LINE OUT line output. The mixing ratio of the microphone and line channels is
maintained when adjusting the mix volume. The maximum volume (control to the right stop) corresponds
to the volume that is reached when no external volume control is connected to the device. Please observe
the correct assignment of the terminal block poles (see TERMINAL BLOCK CONNECTIONS in this manual).
SETTINGS
10
DIP switch 1 MONO / STEREO:
STEREO: A stereo signal applied to LINE IN is output in stereo at the line output LINE OUT 1 / 2.
MONO: A stereo signal applied to LINE IN is summed to mono and output at the line output LINE OUT 1 / 2.
DIP switch 2 P24V:
If a condenser microphone is used, 24 V phantom power must be activated (switch -> ON). Always make
sure that the microphone is connected and the channel volume is set to minimum before switching
on phantom power. Before disconnecting the microphone from the device, turn the channel volume to
minimum and then deactivate phantom power (switch -> OFF).
DIP switch 3 -20dB:
Switch for attenuating the signal level at the MIC IN microphone input by 20 dB (switch -> ON).
STANDBY BUTTON AND POWER SYMBOL
11
Press the button to activate standby mode and again to deactivate standby mode. The power symbol
lights up red when standby mode is activated. When standby mode is deactivated and the device is
operational, the symbol lights up white.
MIC VOLUME
12
Volume control for the microphone channel. Turning to the right increases the volume, turning to the
left decreases it.
12
13
15
14
11
9
Publicité
