ROBBE Power Peak Twin EQ-BID Notice D'utilisation page 67

polarity reversal, overloading and mechanical stress.
• Please include a concise, accurate description of the fault to help us locate the problem.
liability exclusion
This battery charger is designed and approved solely for the purpose of charging
the batteries defined in the operating instructions. robbe Modellsport shall accept
no liability whatsoever if the charger has been used for any other than the intended
purpose.
Adhering to the instructions, the conditions and methods of use, as well as application
chosen, the maintenance of the charger and the batteries cannot be supervised by robbe
Modellsport.
For this reason we accept no liability for loss, damage or costs which are due to the erro-
neous use and operation of our products, or are connected with such operation in any way.
Unless otherwise prescribed by law, our obligation to compensate, irregardless of the legal
reasons, shall be limited to a maximum of the invoice value of the robbe product immedia-
tely and directly involved in the event in which the damages occurred. This does not apply,
if the Company is found to be subject to unlimited liability according to binding statutory
regulations concerning pre-meditated, deliberate or gross negligence.
18. DISPOSAl OF USED EQUIPMENT
Electronic equipment should not be simply thrown into the normal household
waste. For this reason,the Power Peak ® Twin EQ-BID bears the symbol
shown here. This symbol means that you should dispose of electrical and
electronic equipment separately from the household waste at the end of its
useful life. Dispose of the battery charger at your local municipal collection
point or recycling centre. This requirement applies to member countries of
the European Union as well as other European countries with a separate
waste collection system.
Operating Instructions
Power Peak ® Twin EQ-BID
33