Dynasty Fireplaces Allegro Serie Manuel D'installation & D'utilisation page 12

4. Locate the oval shaped opening on both sides of the fireplaces, underneath the top trim. From
the inside of the panel, secure the screw through the oval to the wall studs.
5. Place fireplace media onto flame bed and place glass back on.
6. Put trim piece onto fireplace and check for fit.
2.4 INSTALLATION PROCEDURE – BUILT-IN
NOTE: There are four rubber feet on the bottom of the fireplace that can be
removed before installation
1. The built-in installation method will allow for a deeper recessed installation made to
accommodate thicker finishing material and offer more design variations. Build frame according
to framing dimensions on previous page and ensure a power source is available.
© 2023 Dynasty Fireplaces | V 1.0.0 - 12 -